Private Eye / Dirty Harry Hardware Kit

Description

A fully printable 22LR Single action revolver. Available in Long (Dirty Harry) and Short (Private Eye) variants.

Kits include:

Item Included
M3x20 screws (1 needs to be sharpened for a firing pin) 16
M3x22 screws (for trigger and hammer) 2
M3 locking nuts (for trigger and hammer screws) 2
M3x8 screw (trim to ~7mm in length) 1
M3 nuts 17
4mm x 40mm Stainless Dowel pin 1
1.500″ sections of barrel liner 6
2.5″ or 5.5″ section of barrel liner 1
Alignment/Locking Arm Spring 0.625″ Long, 0.240″ OD, 0.204″ ID 1
Trigger Spring 0.440″ Long, 0.180″ OD, 0.152″ ID 1
Hammer Spring 12″ Long, 0.328″ OD (must cut to ~1.75″ length) 1
Index Arm Spring 90 Degree, 0.235″ OD 1

 

THIS IS AN ADVANCED BUILD AND SHOULD ONLY BE ATTEMPTED BY EXPERIENCED BUILDERS. IN ADDITION TO THE EXTRA RISK CAUSED BY THE GAP BETWEEN THE CYLINDER AND BARREL, THE TOLERANCES AND FINE TUNING REQUIRED TO COMPLETE THIS BUILD ARE MORE THAN ON MANY OTHER BUILDS. THIS BUILD IS STILL IN PUBLIC BETA. PROCEED WITH CAUTION.

Additional information

Weight .75 lbs
Dimensions 4 × 4 × 2 in
Barrel Length

2.5", 5.5"

Reviews

There are no reviews yet.

Be the first to review “Private Eye / Dirty Harry Hardware Kit”

Your email address will not be published. Required fields are marked *

$109.99$124.99

Related Products